Used for data logging air fuel ratio while tuning with Support Tool. 2ģ A/F Sensor Harness ( ) Used to connect a wide band O2 sensor 0-5 volt analog signal to the e-manage Option port. Connects the e-01 Center Unit to the e-manage Ultimate OPTION port. Profec e-01 to e-manage Ultimate pressure sensor harness( ) Used to allow the e-manage Ultimate to monitor manifold pressure through the e-01 pressure sensor reading. Sensor is a 0-5 volt sensor and can read up to 3 bar. This does not replace the factory sensor, but is used only for tuning the e-manage unit. Pressure Sensor with Pressure Sensor Harness ( & ) Used for monitoring manifold pressure with the e-manage system. The e-manage Ultimate has a third connector which is this supplement harness. Connector 1 and 2 are the same for e-manage and e-manage Ultimate. 1Ģ Supplement Harness ( ) Harness that is required if upgrading from the e-manage (blue) to e-manage Ultimate. Complete Harness Kit-1.2m long ( ) Complete Harness Kit-2.5m long ( ) Three connector harness kit used for e-manage Ultimate. 1 e-manage Ultimate ECU Manager e-manage Ultimate Components e-manage Ultimate Main Unit ( ) Advanced Piggy-back Engine Management Unit.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |